SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2433 (COMPONENT LOCATIONS - ELECTRICAL CENTER IDENTIFICATION VIEWS)ELECTRICAL CENTER IDENTIFICATION VIEWSJUNCTION BLOCK - LEFT I/P X10
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Junction Block - Left I/P X10

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Junction Block - Left I/P X10
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Junction Block - Left I/P X10 Connector End View
GM1665718Courtesy of GENERAL MOTORS CORP.
Junction Block - Left I/P X10

Pin Wire Circuit Function
1 0.5 RD/WH 240 Battery Positive Voltage (TQ5)
0.5 RD/WH 240 Battery Positive Voltage (TRW or UG1)
2 0.35 OG 6815 Inadvertent Power Control
3 0.35 PK 1691 Backup Lamp Relay Control (DF5)
4 0.35 BN/WH 230 Instrument Panel Lamp Control
0.35 BN/WH 230 Instrument Panel Lamp Control (CJ3 without UK6)
5 - - Not Used
6 0.35 D-GN 6134 Linear Interconnect Network Bus
7 0.35 GY 1690 Automatic Day/Night Mirror Signal (DL3 or DR4)
8 0.35 D-BU 38 Backup Lamp Control (DL3 or DR4)
Connector Part Information
  • Harness Type: Headliner
  • OEM Connector: 13516830
  • Service Connector: 19149291
  • Description: 8-Way F GT 280 Series (GY)

Terminal Part Information
  • Terminated Lead: Service by Connector Assembly - 19149291
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 13525970/4
  • Core/Insulation Crimp: E/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.