SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2357 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - M THROUGH R)COMPONENT CONNECTOR END VIEWS - M THROUGH RPOWER STEERING CONTROL MODULE (PSCM) X1 (JL7)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Power Steering Control Module (PSCM) X1 (JL7)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Power Steering Control Module (PSCM) X1 (JL7)
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Steering Control Module (PSCM) X1 (JL7)
GM823290Courtesy of GENERAL MOTORS CORP.
Power Steering Control Module (PSCM) X1 (JL7)

Pin Wire Circuit Function
1 0.35 RD 3340 Battery Positive Voltage
2 - - Not Used
3 0.35 YE 7592 Actuator Front Active Signal U
4 0.35 BK 350 Ground
5 0.35 WH 7586 Actuator Front Active Signal W
6 - - Not Used
7 0.35 D-GN 7587 Actuator Front Active Signal Motor V
8 0.35 BN 7588 Actuator Front Active Signal Motor U
9 - - Not Used
10 0.35 BARE - Drain Wire
11 0.35 D-GN/RD 7589 Actuator Front Active Signal V
12 0.35 GY 7590 Actuator Front Active Signal Ground
13 - - Not Used
14 0.35 D-BU 7591 Actuator Front Active Signal Motor W
Connector Part Information 
  • Harness: Instrument Panel
  • OEM: 7283-6447-40
  • Service: 88956524
  • Description: 14-Way F Hybrid Series (L-GY)
Terminal Part Information 
  • Terminal/Tray: Service by Connector Assembly - 7283-6447-40
  • Core/Insulation Crimp: Not Available
  • Release Tool/Test Probe: Pending
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.