SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2339 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSFRONT SEAT ADJUSTER REPLACEMENT
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Front Seat Adjuster Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Front Seat Adjuster Replacement
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Seat Adjuster
GM1702658Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the front seat. Refer to Bucket Seat Replacement .
  2. Remove the seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .
  3. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .
1 Seat Cushion Frame

Procedure

  1. Pull up from the front and slide forward to remove the adjuster assembly.
  2. Disconnect the electrical connectors and wiring from the seat cushion frame.
  3. If replacing the frame, transfer the components as necessary.
2 Seat Back Frame Nut (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  30 N.m (22 lb ft)
3 Front Seat Adjuster
Tip:  Disconnect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.