Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2313 (VEHICLE DIAGNOSTIC INFORMATION - SCAN TOOL INFORMATION)SPECIFICATIONSSIDE OBJECT SENSOR MODULE SCAN TOOL INFORMATION (RIGHT)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Side Object Sensor Module Scan Tool Information (Right)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Side Object Sensor Module Scan Tool Information (Right)
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Right Side Object Detection Scan Tool Parameters
| Parameter | System State | Expected Value | Definition |
|---|---|---|---|
| Operating Conditions: Ignition ON | |||
| Beam 1-7 Range | - | cm | The scan tool displays the range in centimeters. |
| Driver Interface 1-16 History | - | Enabled | The scan tool displays Enabled, Disabled, Turn Signal, Clean Required, Service Required and Unavailable. This captures any interactions with the sensors. |
| Right SOD Sensor Status | - | Low Power | The scan tool displays Low Power, OFF, Disabled Reporting, Not Reporting and Blocked. This is the status of the right side object detection sensor. |
| Obj Present in Alert Zone | - | No | The scan tool displays Yes or No. Yes is displayed if an object is detected in the specified alert zone. |
| Object in Beam 1-7 Present | - | No | The scan tool displays Yes or No. Yes is displayed when an object is detected in the specified beam area. |
Right Side Object Detection Module Output Controls
| Scan Tool Output Control | Description |
|---|---|
| Force Static Alert Zone | This output control calibrates the right side object detection sensor |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.