Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2306 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSRADIATOR OUTLET HOSE REPLACEMENT (LLT)INSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Radiator Outlet Hose At Radiator (LLT)

Courtesy of GENERAL MOTORS CORP.

Install the outlet radiator hose into the vehicle.

NOTE: Lubricate the inside diameters of the hoses with clean coolant prior to installation.

Using the J 38185: Hose Clamp Pliers, disengage the tension on the hose clamp (1) and Install the radiator outlet hose (2) to the engine.

Fig 2: Radiator Outlet Hose At Engine (LLT)

Courtesy of GENERAL MOTORS CORP.

Using the J 38185: Hose Clamp Pliers, disengage the tension on the hose clamp and install the radiator outlet hose to the radiator.
Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (GE 47716) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.