Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper console trim. Refer to Front Floor Upper Console Trim Plate ReplacementΒ .
  2. Remove the shiftier bezel. Refer to Console Shift Lever Bezel ReplacementΒ .
  3. Fig 1: Front Floor Console & Retaining Bolts
    GM1442967Courtesy of GENERAL MOTORS CORP.
  4. Move the driver and passenger front seat in order to access the retaining bolts.
  5. Reposition the carpet in order to access the retaining bolts.
  6. Remove the retaining bolts.
  7. Fig 2: Front Floor Console Electrical Connectors
    GM1442969Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the console electrical connectors.
  9. Lift the console upward in order to release the retainers securing the rear of the console to the vehicle.
  10. Remove the console from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.