Wireless Communication Interface Antenna Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Wireless Communication Interface Antenna Replacement
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Wireless Communication Interface Antenna
GM2089082Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the right rear compartment trim. Refer to Rear Compartment Trim Panel Replacement
  2. Refer to the Communication Interface Module Communication Interface Module ReplacementΒ  if necessary.
1 Wireless Communication Interface Antenna Bluetooth Module
Procedure:Β 
Unsnap the Antenna from Communication Module.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.