Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2207 (COMPONENT LOCATIONS - FRONT OF VEHICLE/ENGINE COMPARTMENT COMPONENT VIEWS)FRONT OF VEHICLE/ENGINE COMPARTMENT COMPONENT VIEWSHYBRID CONTROL ELECTRONIC COMPONENT VIEWS (HP2)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Hybrid Control Electronic Component Views (HP2)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Hybrid Control Electronic Component Views (HP2)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Accessory DC Power Control Module |
| 2 | Drive Motor Generator Battery |
| 3 | Drive Motor Generator Battery Control Module |
| 4 | Drive Motor Battery Cable Terminal Extension Cover |
| 5 | Drive Motor Battery 300 Volt Positive and Negative Cable Assembly |
| 6 | Drive Motor Generator Power Inverter Module 3 Phase Cable Assembly |
| 7 | Drive Motor with Generator Assembly - 2nd Position |
| 8 | Transmission Power Inverter Module (3 Phase) Cable Cover |
| 9 | Automatic Transmission Auxiliary Fluid Pump Control Module |
| 10 | Automatic Transmission Auxiliary Fluid Pump |
| 11 | Drive Motor with Generator Assembly - 1st Position |
| 12 | A/C Compressor |
| 13 | Drive Motor Generator Power Inverter Module |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.