Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 220 (STEERING LINKAGE (NON-RACK & PINION))REPAIR INSTRUCTIONSSTEERING LINKAGE INSPECTION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Steering Linkage Inspection
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Steering Linkage Inspection
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and suitably support the vehicle on safety stands.
- Turn the ignition switch to the ON position.
- With the aid of an assistant, move the tire back and forth.
- Inspect for excessive vertical or lateral movement and/or looseness in the pivot joints.
- Tie rod ends
- Idler arm
- Pitman arm
- Replace any worn or damaged pivot joints.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.