Typical Scan Tool Data

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Typical Scan Tool Data
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
TC Vane Position Sensor

Circuit Short to Ground Open Short to Voltage
Operating Conditions:Β  Ignition ON, Engine Running
Parameter Normal Range:Β  Varies1
Turbocharger Vane Position Sensor 5 V Reference 0% 0% 100%
Turbocharger Vane Position Sensor Signal 0% 0% 100%
Turbocharger Vane Position Sensor Low Reference - 100% -
1 TC Vane Position Sensor parameter matches Desired TC Vane Position parameter
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.