Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2129 (CONFIGURABLE CUSTOMER CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B3622COMPONENT TESTING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Component Testing
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Component Testing
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the right steering wheel control switch.
- Test the resistance between the voltage reference terminal 3 and the signal terminal 4 while depressing the appropriate steering wheel controls switch listed below.
- If not the specified range, replace the steering wheel switch.
| Function Switch | Minimum Resistance Value | Maximum Resistance Value |
|---|---|---|
| Mute/Voice Recognition | 1.0k Ohms | 1.4k Ohms |
| Volume Down | 1.3k Ohms | 1.7k Ohms |
| Volume Up | 1.7k Ohms | 2.1k Ohms |
| Previous | 2.2k Ohms | 2.6k Ohms |
| Next | 2.8k Ohms | 3.2k Ohms |
| Source | 3.6k Ohms | 4.0k Ohms |
| Seek | 5.1k Ohms | 5.5k Ohms |
| No Switch Pressed | O.L. | O.L. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.