SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2103 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP REPLACEMENT (6.6L)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. Refer to Drive Belt Replacement .
  2. Place a drain pan under the vehicle.
    3. Fig 1: View Of Power Steering Pump Rear Bracket & Bolts
    GM1891139Courtesy of GENERAL MOTORS CORP.
  3. Remove the bolts (1) from the rear of the pump.
    4. Fig 2: View Of Power Steering Pump Front Bracket & Bolts
    GM698146Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts from the front of the pump bracket.
    5. NOTE: Note the location of the battery cables for reinstallation.
  5. Disconnect the negative battery clip from the power steering pump front bracket.
    6. Fig 3: View Of Power Steering Return Hoses, Clamps & Power Steering Pump
    GM898607Courtesy of GENERAL MOTORS CORP.
  6. Remove the power steering return hoses (2, 4) from the power steering pump.
    7. Fig 4: View Of Power Steering Pressure Hose & Power Steering Pump
    GM898604Courtesy of GENERAL MOTORS CORP.
  7. Remove the power steering pump from the accessory mounting bracket to gain access to the power brake booster inlet pipe (2).
  8. Remove the power brake booster inlet pipe from the power steering pump.
  9. Remove the power steering pump from the vehicle.
  10. Remove the power steering pulley. Refer to Power Steering Pump Pulley Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L)  or Power Steering Pump Pulley Replacement (6.6L) .
  11. Remove the front bracket from the power steering pump.
  12. Remove the rear bracket from the power steering pump.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.