Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exhaust Gas Recirculation Valve Temperature Sensor - Position 1
GM2375384Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct ReplacementΒ .
1 Exhaust Gas Recirculation Temperature Sensor
CAUTION: Refer to Fastener Caution .

Procedure:Β 
Disconnect the electrical connector.

Tighten:Β  44 N.m (32 lb ft)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.