Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Air Filter Element
    GM1606539Courtesy of GENERAL MOTORS CORP.
  1. Stand facing the front fender on the passenger side of the vehicle. Insert the element into the housing. Place the palm of your hand on the inboard end of the element, and press the element into position.
  2. Press both downward and inboard until the outboard end of the element clicks into place inboard of the locating tab.
  3. CAUTION: Refer to Fastener Caution .
  4. Install the air cleaner housing door and tighten the screw.

    Tighten:Β  Tighten the screw to 4 N.m (35 lb in).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.