SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2070 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REGULATOR REPLACEMENT (MANUAL)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Front Side Door Window Regulator Replacement (Manual)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Front Side Door Window Regulator Replacement (Manual)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Side Door Window Regulator (Manual)
GM2244558Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedures: 
Remove the window handle and the front side door trim panel. Refer to Front Side Door Trim Panel Replacement (SLT, A95) or Front Side Door Trim Panel Replacement (Except YE9 or SLT) .
1 Front Side Door Window Regulator Bolts (Qty: 5)
CAUTION: Refer to Fastener Caution .

Procedure

  1. Remove the front side door water deflector.
  2. Position window to access the front side door window regulator guide bolts.

    Front window regulator guide nuts to window. Refer to Front Side Door Window Replacement .

    Loosen the nuts on the window regulator guide. Do Not remove from the guide.

  3. Raise the window to the fully up position, tape in place.

Tighten:  10 N.m (89 lb in)
2 Front Side Door Window Regulator
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.