SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2061 (CELLULAR SYSTEMS, ENTERTAINMENT SYSTEMS & NAVIGATION SYSTEMS)REPAIR INSTRUCTIONSRADIO ANTENNA CABLE EXTENSION CABLE REPLACEMENT (WITHOUT RPO SLT)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Radio Antenna Cable Extension Cable Replacement (without RPO SLT)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Radio Antenna Cable Extension Cable Replacement (without RPO SLT)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radio Antenna Cable Extension Cable (Without RPO SLT)
GM1802300Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel upper trim pad. Refer to Instrument Panel Upper Trim Panel with Windshield Defroster Nozzle Grille Replacement (with RPO SLT) or Instrument Panel Upper Trim Panel with Windshield Defroster Nozzle Grille Replacement (without RPO SLT) .
  2. Remove the radio. Refer to Radio Replacement (With RPO SLT)  or Radio Replacement (Without RPO SLT) .
  3. Remove the instrument panel upper compartment. Refer to Instrument Panel Upper Compartment Replacement .
1 Radio Antenna Extension Cable Assembly
Tip: 
  • Disconnect the extension cable from the antenna.
  • Disconnect the extension cable from the radio.
  • Disconnect the extension cable from the center HVAC duct.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.