SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2060 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSREAR LICENSE PLATE LAMP BULB REPLACEMENT
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Rear License Plate Lamp Bulb Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Rear License Plate Lamp Bulb Replacement
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear License Lamp Bulb
GM1923749Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Procedure

  1. Reach under the rear bumper for the bulb socket.
  2. Turn the bulb socket counter-clockwise and pull the bulb socket out of the connector.
  3. Pull the old bulb from the socket, keeping the bulb straight as you pull it out.
  4. Install the new bulb.
1 Bulb Socket
2 Rear License Plate Lamp Bulb
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.