Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2055 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSROOF CONSOLE REPLACEMENT

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Roof Console Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Roof Console Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Roof Console

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Roof Console Dome and Reading Lamp Lens
2	Roof Console Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
3	Roof Console Assembly CAUTION: Do not exert downward force at the forward or rearward edge of the roof console assembly as irreversible damage will occur. Procedures Grasp the right and left sides of the roof console assembly where indicated with arrows and pull downward using equal force on each side in order to release the retainer clips securing the overhead console assembly to the headlining assembly. Disconnect the electrical connectors. If replacing roof console assembly, transfer all necessary components.
4	Roof Console Retainers (Qty: 2)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.