SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1976 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSFAN CONTROL MODULE REPLACEMENT (HP5)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Fan Control Module Replacement (HP5)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Fan Control Module Replacement (HP5)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fan Control Module
GM2148062Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LCS)
  2. Remove underhood electrical block. Refer to Underhood Electrical Center or Junction Block Replacement (HP5)
  3. Disconnect electrical connectors from cooling fan control module.
1 Cooling Fan Control Module Bolt
CAUTION: Refer to Fastener Caution .

Tighten:  8 N.m (71 lb in)
2 Cooling Fan Control Module
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.