Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1935 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B0085 OR B0086CIRCUIT/SYSTEM TESTING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Testing
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Side impact sensor
- SDM module
- Side impact sensor wiring harness connector
- SDM wiring harness connector
- Ignition OFF, disconnect the appropriate side impact sensor connector.
- Disconnect the harness connector at the SDM.
- Ignition ON, test for less than 1 volt between the side impact sensor high circuit terminal B and ground.
- If greater than the specified range, test the circuit for a short to voltage.
- Ignition ON, test for less than 1 volt between the side impact sensor low circuit terminal A and ground.
- If greater than the specified range, test the circuit for a short to voltage.
- Test for infinite resistance between the side impact sensor high circuit terminal B and ground.
- If less than infinite resistance, test the circuit for a short to ground.
- Test for less than 1 ohm between the following side impact sensor high circuit terminals.
- Right side impact sensor terminal B and SDM harness connector terminal 43.
- Left side impact sensor terminal B and SDM harness connector terminal 42.
- If greater than the specified range, test the circuit for an open/high resistance.
- Test for less than 1 ohm between the following side impact sensor low circuit terminals.
- Right side impact sensor terminal A and SDM harness connector terminal 41.
- Left side impact sensor terminal A and SDM harness connector terminal 40.
- If greater than the specified range, test the circuit for an open/high resistance.
- If all circuits test normal, replace the appropriate side impact sensor.
- Reconnect all SIR components. Ignition ON, with a scan tool clear and recheck for DTCs.
- If the side impact sensor DTC returns and is current, replace the SDM.
IMPORTANT:
Refer to SIR Service Precautions .
When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector:
When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.