Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1931 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSHIGH MOUNT STOP LAMP REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Washer Nozzle Screws

Courtesy of GENERAL MOTORS CORP.

Install the washer nozzles (3) into the rear high mounted stop lamp assembly (4).

CAUTION: Refer to Fastener Caution .

Install the rear window washer nozzle screws (1). Tighten the screws to 2 N.m (18 lb in).

Fig 2: High Mounted Stop Lamp Screws

Courtesy of GENERAL MOTORS CORP.

Position the high mounted stop lamp (3) to the rear spoiler bracket.
Install the screws (1) to secure the high mounted stop lamp (3) to the rear spoiler bracket. Tighten the screws 2 N.m (18 lb in).
Position and secure the high mounted stop lamp electrical connector (2) to the spoiler bracket.
Secure the washer hose to the spoiler.
Install the rear spoiler to the vehicle. Refer to Rear Spoiler Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.