Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1925 (EXTERIOR TRIM SYSTEM)REPAIR INSTRUCTIONSFRONT DOOR FRAME APPLIQUE REPLACEMENT

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Front Door Frame Applique Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Front Door Frame Applique Replacement

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Door Frame Applique

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Door Frame Applique Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Procedure Apply masking tape to the door frame and applique. Loosen the primary door weatherstrip in the front to expose the front screws. Place the front door window in the full down position. Tighten: 1.5 N.m (13 lb in)
2	Front Door Frame Applique
3	Front Door Rear Frame Applique Screw (Qty: 4) Procedure Apply masking tape to the door frame and applique. Pull the window channel weatherstrip from the applique to expose the screws. Tip: Place the front door window in the full down position. Tighten: 1.5 N.m (13 lb in)
4	Front Door Rear Frame Applique Tip: Pull the applique up and away from the outer seal weatherstrip.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.