Circuit/System Verification

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTCs P003A, P0047, P0048, P0087, P0101, P0201-P0208, P02A1, P02A5, P02A9, P02AD, P02B1, P02B5, P02B9, P02E0, P02E7-P02E9, P029D, P0234, P0299, P0300-P0308, P0401, P0402, P046C, P0545, P0546, P0698, P0699, P2032, P2033, P2269, P2453, or P2563 are not set.
  2. Engine running at a warm stabilized idle, observe the scan tool Particulate Filt. Pressure Variance parameter. The value should be between 0-3 kPa.
  3. Verify the following scan tool parameters:
    • Engine Run Time Since Last DPF Regeneration parameter-The value should be less than 17.5 hours.
    • Fuel Used Since Last DPF Regeneration parameter-The value should be less than 213 liters (57 gallons).
    • Distance Since Last DPF Regeneration parameter-The value should be less than 804 kilometers (500 miles) at sea level, or less than 503 kilometers (312 miles) when equal to or above 10,000 feet altitude.
  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.