Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1894 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L LMM - DTC P0016 TO DTC P02E0)DTC P0106CIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Verification
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that DTCs P0698 or P0699 are not set.
- If any of the DTCs are set, refer to DTC P0698 or P0699 .
- Verify that restrictions do not exist in the exhaust system. Refer to Restricted Exhaust .
- Verify that the engine is in good mechanical condition before continuing with this diagnostic. Refer to Symptoms - Engine Mechanical .
- Ignition OFF for 90 seconds, determine the current vehicle testing altitude.
- Ignition ON, observe the scan tool MAP Sensor parameters. Compare the parameter to the Altitude Versus Barometric Pressure . The BARO sensor pressure parameter should be within the specified range indicated in the table.
- Ignition ON, observe the scan tool MAP and BARO parameters. The MAP and BARO sensor parameters should be within 14 kPa of each other.
- Engine running, observe the scan tool MAP Sensor parameter. Slowly increase the engine speed to 2,000 RPM, then allow the engine speed to return to a stable idle. The MAP Sensor parameter should increment to a higher value at 2,000 RPM and then return to near BARO at idle speed.
- Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.