Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1892 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 4.8L, 5.3L OR 6.0L - DTC P0010 TO DTC P0230)DTC P0106COMPONENT TESTINGSKEWED SENSOR TEST
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Skewed Sensor Test
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Skewed Sensor Test
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
You must perform the Circuit/System Testing in order to verify the integrity of the MAP sensor circuits before proceeding with the Component Testing.
- Using the following steps and referencing the table below will determine if the MAP sensor is skewed.
- Ignition ON, engine OFF, observe the MAP sensor scan tool parameter.
- Use the observed MAP Sensor Scan Tool parameter that is closest to a value that is indicated in the first column.
- Using the J 23738-A or the J 35555 to apply 5 in Hg of vacuum to the MAP sensor, the parameter in the first column should decrease by 17 kPa. The acceptable range is indicated in the second column.
- Using the J 23738-A or the J 35555 to apply 10 in Hg of vacuum to the MAP sensor, the parameter in the first column should decrease by 34 kPa. The acceptable range is indicated in the third column.
| Ignition ON, Engine OFF, MAP Sensor Parameter | MAP Sensor Parameter With 5 Inches of Vacuum Applied | MAP Sensor Parameter With 10 Inches of Vacuum Applied |
|---|---|---|
| 100 kPa | 79-87 kPa | 62-70 kPa |
| 95 kPa | 74-82 kPa | 57-65 kPa |
| 90 kPa | 69-77 kPa | 52-60 kPa |
| 80 kPa | 59-67 kPa | 42-50 kPa |
| 70 kPa | 49-57 kPa | 32-40 kPa |
| 60 kPa | 39-47 kPa | 22-30 kPa |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.