Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1892 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 4.8L, 5.3L OR 6.0L - DTC P0010 TO DTC P0230)DTC P0011TYPICAL SCAN TOOL DATA TABLENOTES
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Typical Scan Tool Data Table: Notes
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CMP Command
| Display Parameters | Short to Ground | Open/High Resistance | Short to Voltage |
|---|---|---|---|
| Operating Conditions:
Engine speed greater than 900 RPMs in Park Parameter Normal Range: 0-100% |
|||
| CMP Command | 0% | 0% | 0% |
Desired CMP
| Display Parameters | Short to Ground | Open/High Resistance | Short to Voltage |
|---|---|---|---|
| Operating Conditions:
Engine speed greater than 900 RPMs in Park Parameter Normal Range: 0-31° |
|||
| Desired CMP | 0° | 0° | 0° |
CMP Angle
| Display Parameters | Short to Ground | Open/High Resistance | Short to Voltage |
|---|---|---|---|
| Operating Conditions:
Engine speed greater than 900 RPMs in Park Parameter Normal Range: 0-31° |
|||
| CMP Angle | 0° | 0° | 0° |
CMP Variance
| Display Parameters | Short to Ground | Open/High Resistance | Short to Voltage |
|---|---|---|---|
| Operating Conditions:
Engine speed greater than 900 RPMs in Park Parameter Normal Range: 0° |
|||
| CMP Variance | 0° | 0° | 0° |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.