Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1884 (TIRE PRESSURE MONITORING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC CODE INDEX
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Diagnostic Code Index
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Diagnostic Code Index
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| DTC C0569 | C0569 00: System Configuration Error |
| DTC C0750, C0755, C0760, or C0765 | C0750 00: Left Front Low Tire Pressure Sensor C0750 08: Left Front Low Tire Pressure Sensor Signal Invalid C0755 00: Right Front Low Tire Pressure Sensor C0755 08: Right Front Low Tire Pressure Sensor Signal Invalid C0760 00: Left Rear Low Tire Pressure Sensor C0760 08: Left Rear Low Tire Pressure Sensor Signal Invalid C0765 00: Right Rear Low Tire Pressure Sensor C0765 08: Right Rear Low Tire Pressure Sensor Signal Invalid |
| DTC C0775 | C0775: Low Tire Pressure System Sensors Not Learned |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.