Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1878 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L LMM - INTRODUCTION)REPAIR INSTRUCTIONSENGINE COOLANT TEMPERATURE SENSOR REPLACEMENTREMOVAL PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

Fig 1: Identifying ECT Sensor
Courtesy of GENERAL MOTORS CORP.

Remove the intake manifold tube. Refer to Intake Manifold Tube Replacement (LMM) .
Drain the coolant to a level below the engine coolant temperature (ECT) sensor. Refer to Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (Vac N Fill) .
Disconnect the engine wiring harness electrical connector(s) (1) from the appropriate ECT sensor (s).

Fig 2: Identifying ECT Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the appropriate ECT sensor(s) (1).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.