SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1866 (ANTILOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSREAR WHEEL SPEED SENSOR REPLACEMENT (10.5 AXLE)INSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Wheel Speed Sensor
    GM1372892Courtesy of GENERAL MOTORS CORP.
  1. Install the spacer block and the wheel speed sensor.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the wheel speed sensor retaining bolt and tighten to 14 N.m (124 lb in).
  3. Connect the electrical connector.
  4. For the left rear sensor, install the leaf spring anchor plate. Refer to Leaf Spring Replacement .
  5. Lower the vehicle.
  6. Perform a low speed test to ensure the wheel speed sensor is functioning properly:
    1. Start the engine and allow it to idle.
    2. Check to see if the ABS indicator or the traction assist indicator remains illuminated.
    3. If the ABS indicator or the traction assist indicator remains illuminated, DO NOT proceed to drive the vehicle until it is diagnosed and repaired. Check the wheel speed sensor electrical connector to ensure it is not damaged and is installed properly. If the lamp remains illuminated, refer to Symptoms - Antilock Brake System .
    4. Select a smooth, dry, clean, and level road or large lot that is as free of traffic and obstacles as possible.
    5. Drive the vehicle and maintain a speed of at least 16 km/h (10 mph) for at least 5 seconds.
    6. Stop the vehicle and check to see if the ABS indicator or the traction assist indicator is illuminated.
    7. If an indicator is illuminated, refer to Diagnostic Starting Point - Antilock Brake System .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.