Electronic Traction Control Switch Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Electronic Traction Control Switch Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electronic Traction Control Switch Replacement
GM1891947Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Instrument Panel Cluster Trim Plate Bezel Assembly
Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
2 Traction Control Switch Assembly
Procedure:Β 
Squeeze the retaining tabs on the back of the switch and push the switch out of the cluster trim bezel assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.