SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1860 (WIRING SYSTEMS AND POWER MANAGEMENT - ELECTRICAL CENTER IDENTIFICATION, COMPONENT CONNECTOR & SPLICE PACK CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSTURN SIGNAL/MULTIFUNCTION SWITCH X2
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Turn Signal/Multifunction Switch X2

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Turn Signal/Multifunction Switch X2
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Turn Signal/Multifunction Switch X2 - Connector End View
GM130718Courtesy of GENERAL MOTORS CORP.
Turn Signal/Multifunction Switch X2

Pin Wire Circuit Function
A-B - - Not Used
C 0.35 YE 525 Headlamp Dimmer Switch Low Beam Signal
D 0.35 BK/WH 351 Ground
E 0.35 YE 307 Headlamp Switch Flash to Pass Signal
Connector Part Information 
  • OEM: 15466858
  • Service: See Catalog
  • Description: 5-Way F Metri-Pack 150 Series (CM)
Terminal Part Information 
  • Pins: C-E
  • Terminal/Tray: 12064971/5
  • Core/Insulation Crimp: E/C
  • Release Tool/Test Probe: 12094429/J-35616-14 (GN)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.