SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1860 (WIRING SYSTEMS AND POWER MANAGEMENT - ELECTRICAL CENTER IDENTIFICATION, COMPONENT CONNECTOR & SPLICE PACK CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSHVAC CONTROL ASSEMBLY X2
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

HVAC Control Assembly X2

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION HVAC Control Assembly X2
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: HVAC Control Assembly X2 - Connector End View
GM62469Courtesy of GENERAL MOTORS CORP.
HVAC Control Assembly X2

Pin Wire Circuit Function
A 0.8 YE 60 Blower Motor Low Control
B 0.8 TN 63 Blower Motor Medium Control
C 0.8 L-BU 72 Medium 2 Blower Motor Control
D 0.8 OG 52 Blower Motor High Control
E 1 BN 141 Ignition Voltage
F 0.8 L-BU 733 Air Temperature Door Control
G 1 WH 119 Blower Motor Switch Control
H 0.5 D-GN/WH 762 A/C Request Signal (C60)
Connector Part Information 
  • OEM: 12064998
  • Service: 15306189
  • Description: 8-Way F Metri-Pack 280 Series (BK)
Terminal Part Information 
  • Pins: H
  • Terminal/Tray: 12034046/2
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 12094430/J-35616-4A (PU)
  • Pins: A-G
  • Terminal/Tray: 12066214/2
  • Core/Insulation Crimp: Pins A-D, F - See Terminal Repair Kit
  • Core/Insulation Crimp: Pins E, G - F/D
  • Release Tool/Test Probe: 12094430/J-35616-4A (PU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.