Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1860 (WIRING SYSTEMS AND POWER MANAGEMENT - ELECTRICAL CENTER IDENTIFICATION, COMPONENT CONNECTOR & SPLICE PACK CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSENGINE CONTROL MODULE (ECM) X1 (6.6L)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Engine Control Module (ECM) X1 (6.6L)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Engine Control Module (ECM) X1 (6.6L)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Engine Control Module (ECM) X1 (6.6L)
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| 1 | 1 OG | 5421 | Fuel Injector Supply Voltage 1 |
| 2 | 1 D-BU/WH | 878 | Fuel Injector 8 Control |
| 3 | 1 OG/BK | 877 | Fuel Injector 7 Control |
| 4 | 0.5 D-BU | 2364 | Cooling Fan Speed Signal |
| 5 | 0.5 YE | 492 | Mass Air Flow (MAF) Sensor Signal |
| 6 | 0.5 OG/BK | 469 | Low Reference |
| 7-8 | - | - | Not Used |
| 9 | 0.5 BN | 1174 | Oil Level Switch Signal |
| 10 | - | - | Not Used |
| 11 | 0.5 GY/BK | 6272 | Low Reference |
| 12 | 0.5 GY | 2704 | 5-Volt Reference 3 |
| 13 | 0.5 TN | 5928 | 5-Volt Reference 3 |
| 14 | 0.5 GY | 6054 | 5-Volt Reference 2 |
| 15 | 0.5 GY | 2705 | 5-Volt Reference 2 |
| 16 | - | - | Not Used |
| 17 | 0.5 GY | 2701 | 5-Volt Reference 1 |
| 18 | - | - | Not Used |
| 19 | 0.5 L-GN | 432 | Manifold Absolute Pressure (MAP) Sensor Signal |
| 20 | 0.5 YE | 5947 | Turbocharger Vane Position Sensor Signal |
| 21 | 0.5 L-BU | 1162 | Accelerator Pedal Position (APP) Sensor 2 Signal |
| 22 | 0.5 YE/BK | 508 | Water In Fuel Indicator Control |
| 23 | 0.5 BK | 2755 | Low Reference |
| 24 | 0.5 PU/WH | 2530 | Fuel Pressure Regulator Solenoid Control |
| 25 | 1 PK | 5425 | Fuel Injector Supply Voltage 4 |
| 26 | 1 YE/BK | 846 | Fuel Injector 6 Control |
| 27 | 1 PK/BK | 1746 | Fuel Injector 3 Control |
| 28 | 0.5 WH/BK | 2366 | Cooling Fan Clutch Control |
| 29 | - | - | Not Used |
| 30 | 0.5 OG/BK | 2919 | Low Reference |
| 31-32 | - | - | Not Used |
| 33 | 0.5 GY/BK | 2931 | Low Reference |
| 34 | - | - | Not Used |
| 35 | 0.5 YE/BK | 6055 | Low Reference |
| 36 | 0.5 TN | 2752 | Low Reference |
| 37 | 0.5 GY | 2702 | 5-Volt Reference 3 |
| 38 | 0.5 TN | 1274 | 5-Volt Reference 2 |
| 39 | 0.5 TN | 2917 | 5-Volt Reference 2 |
| 40 | 0.5 PU/WH | 6270 | 5-Volt Reference 1 |
| 41 | 0.5 D-BU | 6259 | 5-Volt Reference 1 |
| 42 | 0.5 TN | 472 | Intake Air Temperature (IAT) Sensor Signal |
| 43 | 0.5 D-BU | 6053 | DPF Sensor Signal |
| 44 | 0.5 TN/WH | 331 | Oil Pressure Sensor Signal |
| 45-46 | - | - | Not Used |
| 47 | 0.5 TN | 2761 | Low Reference |
| 48 | 0.5 D-BU | 5930 | Turbocharger Vane Position Control Solenoid Valve Control Circuit |
| 49 | 1 PU | 5423 | Fuel Injector Supply Voltage 3 |
| 50 | 1 TN/WH | 845 | Fuel Injector 5 Control |
| 51 | 1 L-BU/BK | 844 | Fuel Injector 4 Control |
| 52 | - | - | Not Used |
| 53 | 0.5 YE/BK | 6120 | Low Reference |
| 54-55 | - | - | Not Used |
| 56 | 0.5 D-BU/WH | 6265 | Camshaft Position (CMP) Sensor Signal |
| 57-61 | - | - | Not Used |
| 62 | 0.5 TN | 2760 | Low Reference |
| 63 | 0.5 OG/BK | 5929 | Low Reference |
| 64 | - | - | Not Used |
| 65 | 0.5 L-BU | 6118 | Air Temperature Sensor Signal |
| 66 | 0.5 D-BU | 5277 | Exhaust Gas Recirculation Temperature Sensor 1 Supply Voltage |
| 67 | 0.5 BN/WH | 5763 | Exhaust Gas Recirculation (EGR) Valve Sensor Signal |
| 68 | 0.5 YE | 410 | Engine Coolant Temperature (ECT) Sensor Signal |
| 69 | 0.5 D-BU | 5277 | Exhaust Gas Temperature Sensor Signal |
| 70 | 0.5 BN | 6274 | Low Reference |
| 71 | 0.5 YE/BK | 625 | Starter Enable Relay Control |
| 72 | 0.5 YE | 2834 | Fuel Pressure Regulator Solenoid Control |
| 73 | 1 YE | 5422 | Fuel Injector Supply Voltage 2 |
| 74 | 1 TN | 1744 | Fuel Injector 1 Control |
| 75 | 1 L-GN/BK | 1745 | Fuel Injector 2 Control |
| 76 | 0.5 PK | 1339 | Ignition Voltage |
| 77 | 1 RD/WH | 440 | Battery Positive Voltage |
| 78 | 0.5 PU | 1272 | Low Reference |
| 79 | 0.5 WH/BK | 6271 | Crankshaft Position (CKP) Sensor Signal |
| 80-82 | - | - | Not Used |
| 83 | 0.5 L-BU/WH | 6311 | Torque Converter Clutch (TCC) Brake Signal |
| 84-85 | - | - | Not Used |
| 86 | 0.5 TN | 2753 | Low Reference |
| 87 | - | - | Not Used |
| 88 | 0.5 BN | 6266 | Low Reference |
| 89 | - | - | Not Used |
| 90 | 0.5 L-BU | 5377 | Exhaust Gas Recirculation Temperature Sensor 2 Supply Voltage |
| 91 | 0.5 D-GN | 485 | Throttle Position (TP) Sensor 1 Signal |
| 92 | 0.5 YE | 2918 | Fuel Rail Pressure (FRP) Sensor Signal |
| 93 | 0.5 L-BU | 5377 | Exhaust Gas Temperature Sensor Signal |
| 94 | 0.5 GY/BK | 6290 | Low Reference |
| 95 | 0.5 BN | 6782 | Low Reference |
| 96 | 0.5 WH | 5931 | Low Reference |
Connector Part Information
|
Terminal Part Information
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.