Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cooling fan to the fan clutch. Refer to Fan ReplacementΒ .
  2. Fig 1: Identifying fan clutch assembly
    GM1732059Courtesy of GENERAL MOTORS CORP.
  3. Install the fan clutch assembly to the pulley.
  4. CAUTION: Refer to Fastener Caution .
  5. Install the J 41240-5AΒ  onto the fan clutch nut and tighten to 95 N.m (70 lb ft).

    Install the J 46406Β  in order to secure the pulley.

  6. Install the upper fan shroud. Refer to Engine Coolant Fan Upper Shroud Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L, 7.0L)Β  or Engine Coolant Fan Upper Shroud Replacement (6.6L)Β .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.