SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1848 (FIXED & MOVEABLE WINDOW SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW CHANNEL REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Run Channel & Bolt
    GM568219Courtesy of GENERAL MOTORS CORP.
  1. Install the rear run channel (1) to the door.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the bolt (2) in order to retain the rear run channel (1) to the door.

    Tighten:  Tighten the retaining bolt to 11 N.m (97 lb in).

  3. Install the front door window to the door from the outside of the vehicle.
    4. Fig 2: Front Run Channel & Bolt
    GM568214Courtesy of GENERAL MOTORS CORP.
  4. Install the nuts (3) in order to retain the front door window to the sash.

    Tighten:  Tighten the retaining nuts to 11 N.m (97 lb in).

  5. Note

    Lower the front door window.

  6. Install the front run channel (1) to the door.
  7. Install the bolt (2) in order to retain the front run channel (1) to the door.

    Tighten:  Tighten the retaining bolt to 11 N.m (97 lb in).

  8. Adjust window channel for proper alignment.
  9. Install the inner window sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  10. Install the outer window sealing strip. Refer to Outer Belt Sealing Strip Replacement .
  11. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  12. Install the front door rear garnish. Refer to Front Side Door Rear Garnish Molding Replacement .
  13. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.