Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Header Trim Panel
    GM331976Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear header trim panel, if equipped.
  2. Fig 2: Locating Nuts Retaining Rear Header Speaker Housing To Vehicle
    GM331973Courtesy of GENERAL MOTORS CORP.
  3. Remove the nuts retaining the rear header speaker housing to the vehicle.
  4. Remove the rear header speaker housing from the vehicle.
  5. Disconnect the electrical connector from the speaker.
  6. Remove the screws retaining the rear header speaker to the rear header speaker housing.
  7. Remove the rear header speaker from the rear header speaker housing.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.