SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1844 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM & NAVIGATION SYSTEM)REPAIR INSTRUCTIONSRADIO REAR SPEAKER REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Nuts Retaining Rear Header Speaker Housing To Vehicle
    GM331973Courtesy of GENERAL MOTORS CORP.
  1. Install the rear header speaker to the rear header speaker housing.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the screws in order to retain the rear header speaker to the rear header speaker housing and tighten to 2 N.m (18 lb in).
  3. Connect the electrical connector to the speaker.
  4. Install the rear header speaker housing to the vehicle.
  5. Install the nuts in order to retain the rear header speaker housing to the vehicle and tighten to 6 N.m (53 lb in).
    6. Fig 2: Identifying Rear Header Trim Panel
    GM331976Courtesy of GENERAL MOTORS CORP.
  6. Install the rear header trim panel, if equipped.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.