Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1844 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM & NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC CODE INDEX
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Diagnostic Code Index
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Diagnostic Code Index
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| DTC B1025, B1035, B1045, or B1055 | B1025 01: Audio Output 1 Left Front Circuit Short to Battery B1025 02: Audio Output 1 Left Front Circuit Short to Ground B1035 01: Audio Output 2 Right Front Circuit Short to Battery B1035 02: Audio Output 2 Right Front Circuit Short to Ground B1045 01: Audio Output 3 Left Rear Circuit Short to Battery B1045 02: Audio Output 3 Left Rear Circuit Short to Ground B1055 01: Audio Output 4 Right Rear Circuit Short to Battery B1055 02: Audio Output 4 Right Rear Circuit Short to Ground |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.