Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1844 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM & NAVIGATION SYSTEM)DESCRIPTION AND OPERATIONRADIO/AUDIO SYSTEM DESCRIPTION AND OPERATIONRADIO ERROR MESSAGES
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Radio Error Messages
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Radio Error Messages
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
The Radio may display the following Error Messages (Not all messages may be applicable):
- ERR: This message is displayed when the radio is unable to play the inserted cassette or CD
- LOC: This message is displayed when the radio has entered Theft mode.
- CAL/CAL ERR: This message is displayed when the radio has detected an invalid calibration.
- CDX ERR: Displays if communication is lost with the remote CD changer.
- CHECK CD: Displays when the player encounters a focus or tracking error.
- CHK CDXX: Displays when the CD changer encounters a focus or tracking error.
- CHK TAPE: Displays if a tape has been inserted but is unable to be played due to an error.
- DOOR OPEN: Displays when the CD changer door has been left open.
- NO DISC: Displays when the radio expected a disc to be inserted.
- NONE: Displays when the radio is unable to detect the vehicle speed data information via the serial data circuit.
If an error message is displayed, perform the appropriate diagnostics.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.