Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1807 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSENGINE COOLANT FAN BRACKET REPLACEMENT (LH2)INSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Engine Cooling Fan Bracket (LH2)

Courtesy of GENERAL MOTORS CORP.

Install the fan bracket to the engine.
Install but DO NOT tighten the fan bracket to engine block bolts.
If necessary, with the aid of an assistant, tap the engine ignition until the fan bracket to crankshaft balancer bolt holes are accessible.

CAUTION: Refer to Fastener Caution .

Install the fan bracket to crankshaft balancer bolts.
- Tighten the fan bracket to crankshaft balancer bolts to 24 N.m (18 lb ft).
- Tighten the fan bracket to engine block bolts to 24 N.m (18 lb ft).

Fig 2: View Of Fan

Courtesy of GENERAL MOTORS CORP.

Install the engine cooling fan. Refer to Fan Replacement (LH2) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.