Rear Seat Heater Control Module Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Rear Seat Heater Control Module Replacement
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Back Seat Heater Control Module, Pad, Wire Harness & Frame
GM1481722Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement .
  2. Remove the rear seat back. Refer to Rear Seat Back Replacement .
1 Rear Seat Back Cushion Cover Assembly
Refer to Rear Seat Back Cushion Cover and Pad Replacement .
2 Rear Seat Back Wire Assembly
3 Rear Seat Back Pad Assembly
Refer to Rear Seat Back Cushion Cover and Pad Replacement .
4 Rear Seat Heater Control Module Assembly
Tip:Β  Module can be removed with the seat in the vehicle.
5 Lower Rear Seat Back Harness Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.