Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1772 (SUNROOF SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER SUNROOF MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Verification
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Verification
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the RAP is functioning normally.
- If the RAP is not functioning normally refer to Retained Accessory Power Malfunction .
- With the sunroof in the closed position, press the sunroof open switch. The sunroof should open.
- If the sunroof does not open, refer to Circuit/System Testing , under Power Sunroof Malfunction.
- With the sunroof in the open position, press the sunroof close switch. The sunroof should close.
- If the sunroof does not close, refer to Circuit/System Testing , under Power Sunroof Malfunction.
- With the sunroof in the closed position, operate the sunroof express open feature. The sunroof should fully open.
- If the express open feature does not function, refer to Circuit/System Testing , under Power Sunroof Express Feature Malfunction.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.