Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Low Fob Battery Message
A LOW FOB BATTERY message may be seen on the DIC when the fob's battery voltage has been lower than 2.6 volts for three consecutive ignition cycles (OFF to ACC or OFF to RUN). The RCDLR monitors the voltage of each fob independently; however, if two fobs are present when starting the vehicle, the voltage will be monitored only on the fob that starts the vehicle. For example, if Fob 1 enters from the driver door and Fob 2 enters from the passenger door, the RCDLR will monitor only Fob 1. To determine the fob being monitored, check which driver ID is present when the vehicle is started. The driver ID will correspond with the fob being monitored.
Fob battery voltage may also be observed using the scan tool. The scan tool displays the actual battery signal voltage, as well as the low voltage signal. These parameters may be used to determine which fob has caused the LOW FOB BATTERY message to be displayed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.