SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1750 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSSTARTER MOTOR REPLACEMENT (LLT)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition.
  2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post)  or Battery Negative Cable Disconnection and Connection (LHD With Top Post) .
  3. Remove the left catalytic converter. Refer to Catalytic Converter Replacement - Left Side .
    4. Fig 1: View Of Starter Solenoid Electrical Connector
    GM887710Courtesy of GENERAL MOTORS CORP.
  4. Remove the starter solenoid electrical connector from the starter.
    5. Fig 2: View Of Starter Terminal Nut & Battery Positive Cable
    GM887713Courtesy of GENERAL MOTORS CORP.
  5. Remove the starter terminal nut (1) and the battery positive cable (2) from the starter.
    6. Fig 3: View Of Starter Motor - LY7
    GM887715Courtesy of GENERAL MOTORS CORP.
  6. Remove the starter motor bolts.
  7. Remove the starter motor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.