SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1750 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSENGINE GROUND STRAP REPLACEMENT (LH2)INSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ground Strap, Right Camshaft Cover & Bolt
    GM928269Courtesy of GENERAL MOTORS CORP.
  1. Install the right side ground strap into the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the right side ground strap to cam cover bolt and tighten to 10 N.m (89 lb in).
  3. Install the right side ground strap to cylinder head bolt 25 N.m (18 lb ft).
    4. Fig 2: View Of Left Camshaft Cover Ground Strap & Bolts
    GM928237Courtesy of GENERAL MOTORS CORP.
  4. Install the left side ground strap into the vehicle.
  5. Install the left side ground strap to cam cover bolt 10 N.m (89 lb in).
  6. Install the left side ground strap to cylinder head bolt 25 N.m (18 lb ft).
  7. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.