SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1746 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER REPLACEMENT (WITH CE4)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Windshield Washer Solvent Container Replacement (With CE4)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Windshield Washer Solvent Container Replacement (With CE4)
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Solvent Container, Solvent Pump Hose, Solvent Hose, Container Screws & Container Nut
GM1829332Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the front bumper fascia in order to access and remove the windshield washer container. Refer to Front Bumper Fascia Replacement .
  2. Drain the windshield washer solvent into a suitable clean container.
  3. Disconnect the forward lamp harness electrical connectors from the washer container.
1 Windshield Washer Solvent Hose
2 Headlamp Washer Solvent Pump Hose
3 Washer Container Screws (Qty: 3)
CAUTION: Refer to Fastener Caution .

Tighten:  6 N.m (53 lb in)
4 Washer Container Nut

Tighten:  6 N.m (53 lb in)
5 Windshield Washer Solvent Container
Tip: 
  • Lift the container from the stud on the tie bar reinforcement outer panel and lower the washer container from the vehicle.
  • Transfer parts as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.