SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1746 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER PUMP REPLACEMENT (WITH CE4)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Windshield Washer Pump Replacement (with CE4)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Windshield Washer Pump Replacement (with CE4)
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Windshield Washer Pump
GM1829336Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the right front fascia extension. Refer to Front Bumper Fascia Extension Replacement (DW) or Front Bumper Fascia Extension Replacement (DX) .
  2. Drain the washer solvent into a suitable clean container.
  3. Disconnect the windshield washer pump hose from the windshield washer pump.
  4. Disconnect the windshield washer pump electrical connector from the windshield washer pump.
  5. Disengage the washer pump from the container, pull the top of the pump slightly outward.
  6. Using two flat-bladed tools under the washer pump, pry upward in order to remove the pump.
1 Windshield Washer Pump
Tip:  Discard the old washer pump grommet from the washer container.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.