SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1739 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSDRIVER OR PASSENGER SEAT HEAD RESTRAINT SPEAKER REPLACEMENT
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Driver or Passenger Seat Head Restraint Speaker Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Driver or Passenger Seat Head Restraint Speaker Replacement
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Front Seat Speaker
GM1846526Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the seat back panel. Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement .
1 Front Seat Head Restraint Speaker Grille
Procedure: 
Use a plastic flat bladed tool to remove the speaker grille.
2 Front Seat Head Restraint Speaker Screw (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:  2 N.m (18 lb in)
3 Front Seat Head Restraint Speaker Assembly

Procedure

  1. Cut the speaker wire close to the speaker.
  2. Disconnect the electrical connector and pull out the cut speaker wire and discard.
  3. For installation route the speaker wire rearward from the speaker location between the frame and the seat cover.
  4. Pull the speaker wire down the back of the seat and connect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.