Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1739 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESNAVIGATION SYSTEM - VOICE RECOGNITION INOPERATIVECIRCUIT/SYSTEM TESTINGWITH UE1
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
With UE1
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION With UE1
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X3 harness connector at the CIM.
- Ignition ON, test for 8.5-9.5 volts between the navigation voice signal circuit terminal 2 and ground.
- If less than specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
- If greater than specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
- Ignition ON, test for less then 1 volt between the navigation voice low reference circuit terminal 4 and ground.
- If greater then specified range, test for a short to voltage. If the circuit tests normal, replace the radio.
- Ignition OFF, test for less than 10 ohms between the navigation voice low reference circuit terminal 4 and ground.
- If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the radio.
- Ignition ON, test for 8.5-9.5 volts between the navigation voice signal circuit terminal 2 and the ground.
- If less than specified range, test the drain wire circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
- If all circuits test normal, replace the CIM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.