Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1727 (EXTERIOR TRIM SYSTEM)REPAIR INSTRUCTIONSROCKER PANEL MOLDING REPLACEMENT

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Rocker Panel Molding Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Rocker Panel Molding Replacement

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rocker Panel Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Open both doors on the side the lower rocker molding is being replaced.
1	Integral Retainers (Qty: 5) Tip: Release the lower retainer clips first before releasing the integral clips.
2	Integral Clips (Qty: 11)
3	Lower Rocker Panel Molding

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.